Infortrend EonStor DS S16E-R2240 - 5.5 Replacing a Cooling Module; 5.5.1 For S12 x-Rxxxx Models and S16 series

EonStor DS S12/S16/S24 Series Hardware Manual
Step 6. Secure the PSU to the system by fastening the retention
screw through the PSU extraction handle.
Step 7. Replace the power cord that connects the PSU module to the
mains.
Step 8. Secure the power cord connection using the included cable
clamp.
Step 9. Power on the PSU module.
5.5 Replacing a Cooling Module
5.5.1 For S12x-Rxxxx Models and S16 series
WARNING
DO NOT try to replace the cooling module on your own. Always contact technical
support and let properly trained service personnel take care of the replacement
procedures.
The subsystem is equipped with four cooling fans, two within each power supply.
These cooling modules control the operating temperature within the chassis and
therefore their working integrity should be maintained at all times.
141