Ingenico iCT 200 Series Setup Guide

Ingenico iCT 200 Series Set-Up Guide
Page 1 of 5
CONNECTING/INITIALIZING THE TERMINAL
Turn over terminal and plug the various ends of
the “magic box” connector into the corresponding
outlets in the back of terminal.
Plug Ethernet or phone cable, power cable into the
other end of the magic box.
(Power connector turns terminal on/off).
PIN Pad SETUP
Connect PIN pad into RS232 Port of magic box
Press F
Press 0 -Telium Manager
Press 3 - Initialization
Press 1 - Parameters
Scroll and choose PIN Pad
Select - Autodetect
INTERNET SETUP
Press F
Press 0 -Telium Manager
Press 3 -Initialization
Press 2 –Hardware
Press 2 -Ethernet Setup
Press 1 -Boot Proto
Press 2 –DHCP
Press red cancel button to exit and save
LOADING & CHANGING THE PAPER ROLL
Pull tab on paper roll cover to release and open
cover
Place the paper roll in the compartment as shown
SETTING ADMIN PASSWORD
Press ADMIN to access the Admin menu
Press 3 for SET-UP
Press 3 for SYSTEM SET-UP
Enter default Admin password 000000, press OK
Enter new Admin password
Confirm new Admin password
The Ingenico iCT 200 series are Ethernet based terminal with dial backup and PIN pad connectivity capability
Terminal / Keypad Layout
Menu Layout
The Ingenico iCT 220 menu functions are
arranged in two menus: Transaction and
Administration.
To access letters on the numeric keypad,
double click the letter key quickly until
the desired number appears.
Use yellow button to go back one step
and red button to cancel.

Ingenico iCT 200 Series Specifications

General

Brand	Ingenico
Model	iCT 200 Series
Category	Payment Terminal
Language	English