Ingenico iCT 200 Series Setup Guide

Ingenico iCT 200 Series Set-Up Guide
Page 2 of 5
SYSTEM SET-UP
Press ADMIN to access Admin menu
Select 3 for SET-UP, press OK
Select 3 for SYSTEM SET-UP, press OK
Enter Admin password, press OK
TERMINAL DATE will be set automatically by host
TERMINAL TIME will be set automatically by host
Set MAIN COMM Mode to Ethernet or Dial
If communication mode is Dial set the following
configurations:
Set DIAL PREFIX (commonly 9) if required
Set DIAL TYPE to Tone or Pulse
Set the LINE DETECTION to Yes/No
Set the BAUD RATE to 1200 or 2400
Set ENABLE PRE-DIAL for Debit to Yes/No
Set ENABLE PRE-DIAL for Credit to Yes/No
Set DIAL PARITY to None/Even
Set DATA SIZE to 7 or 8
Set DIAL STOP BITS to 1 or 2
For ETHERNET SETUP choose Ethernet
For DNS SETUP choose automatic Yes/No
If Automatic DNS is set to Yes press OK
If Automatic DNS is set to NO:
Enter primary and secondary IP addresses
For TERMINAL SET-UP choose None/Dynamic/Static
If Set to STATIC:
Enter Mask IP, press OK
COMMUNICATION TO HOST SET-UP
Press ADMIN to access Admin menu
Press 3 for SET-UP
Press 2 for HOST SET-UP
Enter new Admin password, press OK
Enter the 8 digit TERMINAL ID (TID), press OK
Select Ethernet for COMMS Setup
Set FALLBACK TO DIAL to Yes if required
All of the communication parameters come pre-configured.
To validate the configurations following the instructions
below:
Select INPUT Type
IP address should set at 206.152.27.137
NAME should be set at www.ctpaiement.com
PORT NUMBER should be set at: 5085

Ingenico iCT 200 Series Specifications

General

Brand	Ingenico
Model	iCT 200 Series
Category	Payment Terminal
Language	English