Ingenico Move 5000 - Page 3

If you purchased the base with the Move/5000, it will already be paired. No
further setup is required. Otherwise, continue with the setup instructions.
Prepare to connect the Move/5000 to a Bluetooth base:
• Ethernet-Bluetooth support requires that the reader is paired with the
base.
Note: Only Ethernet connections are supported.
• Your Ethernet cable from the router must be connected to the base.
• Fully charge the card reader before pairing. Remove the cover on the bottom of the base to
access the charging port.
• The reader must be resting on the corresponding base in order to complete the pairing
process.
• If multiple readers and bases were purchased, each base can support up to ve readers.
Follow these instructions
(only if you purchased a communications base separately from your Move/5000).
Your card reader will display
Idle Menu / Screen Saver
[ADMIN MODE]
ADMIN MENU
Enter Admin Password
[ADMIN MENU]
[ADMIN MENU]
1 – Download Application
2 – Set Date and Time
3 – Congure Wi-Fi
4 – Congure Mobile
5 – Congure Bluetooth
[ADMIN MENU]
1– Base
What you need to do
Press the Home Menu
[ ]
key to access
the Admin Menu
Select [ADMIN MODE]
Key in the Admin Username/Password and
press Enter
If you don’t know your Admin Password, call
1-888-886-8869. For your security, we don’t send
passwords with processing equipment.
Select [TETRA ADMIN]
Select 5 for Congure Bluetooth
Select 1 for Base
3
CONTINUED ON BACK
Move/5000 Bluetooth Base Pairing