5
Serial port: At least one
Ethernet port: At least one (10M/100M)
IE version: Above 5.0
Resolution ratio: Above 640*480
1 SIM card:
Ensure the card is enabled with data service and its service is not suspended
because of an overdue charge.
Power supply:
220V AC: Alternatively used with the product with DC power
9~26V DC: Ripple voltage < 100 mV
Fixation:
Please place InRouter level and have it installed in an environment with small
vibrational frequency.
The device shall be installed and operated when powered off!
2.2 Installation of SIM/UIM Card
IR6XX-S series apply pop-up card holder. Press the yellow button on the right of the card holder
and the card holder will pop up. Then, install the SIM/UIM card and press the card holder back to
the card slot.
2.3 Installation of Antenna
Slightly rotate the movable part of metal SMA-J interface until it cannot be rotated (at this time,
external thread of antenna cable cannot be seen). Do not forcibly screw the antenna by holding
black rubber lining.
To Next Page
Loading...
