InHand IR611-S - Advanced OpenVPN and Certificate Management

43
Expert Option (not
recommended)
Set expert option, not recommended
N/A
3.6.7 OpenVPN Advanced
From navigation tree, select "VPN>>OpenVPN Advanced" and enter "OpenVPN Advanced"
interface.
Table 3-6-7 Configuration Parameters of OpenVPN Advanced
OpenVPN Advanced
Function description: Configure parameters of OpenVPN Advanced.
Parameters
Description
Default
Enable Client-to-Client
(Server Mode Only)
Click to enable
Disable
Client Management
Enable
Click to enable client management
Enable
Tunnel Name
Set tunnel name
OpenVPN_T_1
Username/CommonName
Set username/commonname
N/A
Password
Set client password
N/A
Client IP (4th byte must be
4n+1)
Set client IP address
N/A
Local Static Route
Set local static route
N/A
Remote Static Route
Set remote static route
N/A
3.6.8 Certificate Management
From navigation tree, select VPN>> Certificate Management, then enter “Certificate
Management” page.
Table 3-6-8 Parameters of Certificate Management
Certificate Management
Function description: Configure parameters of certificate management.
Parameters
Description
Default
Enable SCEP (Simple
Certificate Enrollment
Protocol)
Click to enable
Disable
Protect Key
Set protect key
N/A
Protect Key Confirm
Confirm protect key
N/A
Enable SCEP (Simple Certificate Enrollment Protocol)
Force to Re-enroll
Click to enable force to re-enroll
Disable
Request Status
The system is "ready to refile an enrollment",
Ready to refile