3 0 IDS404 INSTALLER MANUAL NO. 700-277-02A ISSUED SEPT 2004 VER 1.02
IDS404 INSTALLER MANUAL
.coL tnevE eulaV noitcAtluafeD
24
P/O.gorP1enoZ
0
delbasiD
34
P/O.gorP2enoZ
0
delbasiD
44
P/O.gorP3enoZ
0
delbasiD
54
P/O.gorP4enoZ
0
delbasiD
64
P/O.gorPb1enoZ
0
delbasiD
74
P/O.gorPb2enoZ
0
delbasiD
84
P/O.gorPb3enoZ
0
delbasiD
94
P/O.gorPb4enoZ
0
delbasiD
05
P/O.gorP.seR.ttaBwoL
0
delbasiD
15
P/O.gorPliaFMLT
0
delbasiD
25
P/O.gorPerotseRMLT
0
delbasiD
35
P/O.gorPrepmaTneriS
0
delbasiD
45
P/O.gorPrepmaTxoB
0
delbasiD
55
P/OgorPdessapyBenoZ
0
delbasiD
65
P/O.gorPnwodtuhSenoZ
0
delbasiD
Please note the following information on these locations:
05NOITACOL)0=tluafeD(P/O.gorPlarotseRyrettaBwoL
This output will be triggered once the battery voltage has been restored
i.e. the voltage has risen to above 11.9V.
15NOITACOL)0=tluafeD(tuptuOelbammargorPliaFMLT
This output will be triggered if telephone line monitoring is enabled, and
the line voltage drops below 9V for more than 30-60 seconds.
25NOITACOL )0=tluafeD(tuptuOelbammargorPerotseRMLT
This output will be triggered once telephone line monitoring has been
restored to 9V for longer than 30-60 seconds.
35NOITACOL )0=tluafeD(tuptuOelbammargorPrepmaTneriS
The siren tamper output will be triggered if the siren wire is open circuit
for more than 5 seconds or the fuse has blown.
To Next Page
Loading...