3 6 IDS404 INSTALLER MANUAL NO. 700-277-02A ISSUED SEPT 2004 VER 1.02
IDS404 INSTALLER MANUAL
If dual reporting is enabled and the Contact ID reporting format is
required, both the primary and secondary communicator formats need
to be programmed as Contact ID. It is not possible to use Contact ID
in conjunction with a second format e.g.. Domestic Reporting, as the
second format will transmit all codes as FF or F.
It is common not to report stay arming, away arming and disarming for
domestic alarms. To disable the reporting of these functions, program
the following locations:
Arming or Closing Code Location 128 = 0
Disarming or Open Code Location 129 = 0
Home or Stay arming Location 130 = 0
Table 8: Standard Contact ID reporting codes
noitpircseD sedoC noitircseD sedoC
resuybesolC1043ssapyBenoZ0751
mraotuaybesolC3043nwodtuhSenoZ3751
daolnwodybesolC7043larotserenoZ0313
hctiws-yekhtiwesolC9043enozybrepmaT7311
resuybnepO1041repmaTdapyeK7311
daolnwodybnepO7041tuokcoldapyeK7311
hctiws-yekhtiwnepO9041enozcinaP0211
lecnaC6041cinaP0211
noitaloivyralgruB0311cinapdapyeK0211
noitaloivretemireP1311liafCA1031
noitaloivroiretnI2311larotserCA1033
noitaloiv)efaS(ruoH423311yrettabwoL2031
noitaloivtixe/yrtnE4311tropertseT2061
noitaloivthgin/yaD5311erifdapyeK0111
noitaloivroodtuO6311eriF0111
noitaloivrepmaT7311sseruD1211
noitaloivmralaraeN8311lacidemdapyeK0011
repmaTxoB4411
The generic Contact ID reporting code for an alarm caused by a zone
violation is 1130, corresponding to a “BURGLARY” description. If you
wish particular zone violations to be reported with a description other
than BURGLARY an option may be chosen from Table 9 below. The
first digit of the reporting code relevant to that zone must be changed
to the value as indicated in the table.
To Next Page
Loading...