IDS800 INSTALLER MANUAL NO. 700-175-02N ISSUED JUL 2003 VER 1.45 37
IDS800 INSTALLER MANUAL
64-79.
2. Follow the phone number with an 8 second delay by programming
a [15] into the 2 locations immediately following the phone
number (see locations 48-63).
3. Program a [6] in the location immediately after the 8 second
delay. This digit serves to inform the paging network that 6 digits
of data will follow.
4. A [0] must be programmed into the location immediately following
the 6. This [0] serves to terminate the phone number.
5. The account code and reporting codes must be programmed as
normal.
NOTE:
Only the decimal numbers 1-10 may be used for the reporting codes,
the hexadecimal numbers B-F (i.e. 11-15) are not permissible.
Some pager systems may require a termination digit/s to be
communicated. These termination digits inform the pager network that
the message is complete. Any required termination digits must be
programmed into locations 142 and 143. Enter [11] for a “(” and [12] for
a “#”. A [0] in these locations will be ignored.
To achieve the above it may be necessary to join the 2 phone numbers
to create a single number i.e. [5] must be programmed into location
42. If both phone numbers are programmed, the data will be
transmitted alternately to each phone number. If the same number is
programmed into each phone number the data will be sent multiple
times (as programmed to location 125).
EXAMPLE
Assume the following:
1. The paging network number is 705 1373
2. The panel account code is 0123
3. The reporting code for a zone 1 violation is A1
4. The reporting code for a zone 2 violation is A2.
To Next Page
Loading...