IDS800 INSTALLER MANUAL NO. 700-175-02N ISSUED JUL 2003 VER 1.45 39
IDS800 INSTALLER MANUAL
NOTES ON PROGRAMMING TELEPHONE NUMBERS:
To dial a “0” program a [10] into the location.
To dial a “(” program an [11] into the location.
To dial a “#” program a [12] into the location.
To create a 12 second pause in the number program a [14] into
the location.
To create a 4 second pause in the number program a [15] into the
location.
To terminate a telephone number, program a [0] (not 10) into the
location immediately following the last digit of the telephone
number.
36-84NOITACO
6
These locations contain the primary telephone number, which may be
up to sixteen digits long. A four second delay can be programmed at
any point by entering a value of [15] in the respective location.
EXAMPLE
Assuming a phone number consisting of an area code 031, a 4 second
pause and a phone number of 705 1373
noitacoL demmargorPeulaV
8401edocaerafotigidts1-
943 edocaerafotigiddn2-
051 edocaerafotigiddr3-
1551yaleddnoces4-
257 rebmunenohpfotigidts1-
3501rebmunenohpfotigiddn2-
455 rebmunenohpfotigiddr3-
551 rebmunenohpfotigidht4-
653 rebmunenohpfotigidht5-
757 rebmunenohpfotigidht6-
853 rebmunenohpfotigidht7-
950 rebmunetanimret-
To Next Page