IDS800 INSTALLER MANUAL NO. 700-175-02N ISSUED JUL 2003 VER 1.45 41
IDS800 INSTALLER MANUAL
38-28SNOITACO
edocgnitropercinaPdapyeK
This code will be reported if the panic button [P] on the keypad is
pressed.
58-48SNOITACO
edocgnitroperrepmaTdapyeK
The keypad tamper code will be reported if multiple attempts are made
to disarm the panel using the wrong user code. The code will be
reported after 16 incorrect keystrokes i.e. four incorrect user codes.
101-68SNOITACO
sedocgnitroperenoZ
snoitacoL edoCgnitropeR
78-681enoZ
98-882enoZ
19-093enoZ
39-294enoZ
59-495enoZ
79-696enoZ
99-897enoZ
101-0018enoZ
Zone reporting codes will be reported if a violation of a zone causes an
alarm condition. Various conditions will apply as to when an alarm
condition will be registered. These conditions are determined by the
zone characteristics as programmed into locations 1 to 8.
301-201SNOITACO
edocgnitroperliaFCA
The AC fail will only be reported if the AC power is lost for a period
longer than the delay programmed into location 19.
501-401SNOITACO
edocgnitroperlarotseRCA
The AC restoral code will be reported if the AC power was lost for a
period longer than the delay programmed into location 19 and only
after the AC power has been restored for the same period of time.
To Next Page
Loading...