Installation and programming manual
Overview 5
Chapter 1
Overview
Note: The control panels described in this manual have been designed and developed to the highest
standards of quality, reliability and performance. All product components are capable to application
requirements and able to operate in compliance with the related technical specifications when the
temperature external to their casing complies with Category 3k5 of EN60721-3-3:1995.
Danger: The GAS control function is not provided for in the aforesaid standard and therefore cannot
be considered EN54-2 compliant.
Danger: In order to validate the IMQ-SECURITY SYSTEMS certification, and in compliance with EN54-
2, all the manual alarm buttons and fire detectors employed in the system must be
associated with fire detection and alarm functions.
1.1 Application and use
The SmartLight analogue-addressable fire alarm panel manages a single loop that accommodates different
types of fire-security devices (detectors, input modules, outputs, callpoints, fire bells, sirens, etc.). The
maximum loop wire length is 2000 m.
The SmartLight provides supervised outputs which ensure full device functionality. The panel identifies and
signals alarm, pre-alarm, fault, early warning, bypassed zone, test and monitoring conditions.
The system status is indicated on the display and on the system status LEDs. The SmartLight panel
supports up to 4 repeater panels (accessory items) which replicate system data and allow building
occupants with Level 2 authorization to silence and reset the system. The panel also accepts an
extinguishant module (accessory item) that allows it to manage a gas extinguishant system.
The self-addressing feature and reduced-complexity point programming allow fast and easy installation.
Figure 1 - Example of a typical SmartLight installation
A
D
B
C
E
F
To Next Page
Loading...
