initium Promi SD101 - Page 51

Promi SD™ User Manual ver 1.7
www.initium.co.kr
51
No.
Command Response Comments
1) AT<cr>
<cr><lf>OK<cr><lf>
2)
ATZ<cr>
<cr><lf>OK<cr><lf>
Drops all connections, disable Inquiry
and Page scans. Reset the bluetooth
module.
3) AT&F<cr>
<cr><lf>OK<cr><lf>
Reset to factory default state
4)
AT+BTINQ?<cr>
<cr><lf>112233445
5,FriendlyName,Co
D<cr><lf>
<cr><lf>112233445
5,FriendlyName,Co
D<cr><lf>
<cr><lf>112233445
5,FriendlyName,Co
D<cr><lf>
<cr><lf>OK<cr><lf>
Inquiry nearby devices. The OK at
the end means end of inquiry.
5)
ATD112233445566<cr>
<cr><lf>OK<cr><lf>
<cr><lf>CONNECT
<cr><lf> or
<cr><lf>ERROR<cr
><lf>
Connect to the specified device.
If you want to enable Authentication
and Encryption, just set variable as 1.
6)
ATD<cr>
<cr><lf>OK<cr><lf>
<cr><lf>CONNECT
<cr><lf> or
<cr><lf>ERROR<cr
><lf>
Connect to the device that last
succefully connected.
7)
AT+BTSCAN<cr>
<cr><lf>OK<cr><lf>
Enable inquiry and page scans with
timeout of infinity.
8)
AT+BTSCAN,n,to<cr>
<cr><lf>OK<cr><lf>
Enable inquiry or Page scans.
If n=1, disable page and enable
inquiry.
If n=2, enable page and disable
inquiry.
If n=3, enable both page and inquiry.
Scan will be performed during <to>