initium Promi SD101 - Page 52

Promi SD™ User Manual ver 1.7
www.initium.co.kr
52
seconds.
9)
AT+BTSCAN112233445566,to<cr>
<cr><lf>OK<cr><lf>
Will scan of only specifed device.
10)
AT+BTCANCEL<cr>
<cr><lf>OK<cr><lf>
cancel the current pending operation
when the device is inquirying, paging
or scanning mode.
11)
+++
<cr><lf>OK<cr><lf>
Drop from online mode to command
mode.
12)
ATO<cr>
<cr><lf>OK<cr><lf>
Return to online mode if currently
being connected.
13)
ATH<cr>
<cr><lf>OK<cr><lf>
Drop the connection.
14)
AT+BTSEC,Authentication,Encryption
<cr>
<cr><lf>OK<cr><lf>
Same as AT+BTAUTH
15)
AT+BTLAST?<cr>
<cr><lf>OK<cr><lf>
Query the bd-address of last
connected device
16)
AT+BTMODE,n<cr>
<cr><lf>OK<cr><lf>
Sets the mode of device.
If n=0, device operates at Standart
mode which accepts all AT
commaned supported.
If n=1, device operates at Master
mode which try to connect peer
device.
If n=2, device operates at Slave
mode which waiting for connection.
If n=3, device operates at always
connectable mode.
17)
AT+BTNAME="FriendlyName"<cr>
<cr><lf>OK<cr><lf>
Sets the friendly name of this unit.
18)
AT+BTKEY="nnnn"<cr>
<cr><lf>OK<cr><lf>
Sets the Passkey of this unit.
Up to 16 characters.
19)
AT+BTINFO?<cr>
<cr><lf>112233445
566,FriendlyName,
Mode,State,Authent
ication,Encryption<
cr><lf>
<cr><lf>OK<cr><lf>
Retrieve local device information
including BD address, Friendly name,
mode of device, internal operation
state and status of authentication
and encryption features.