initium Promi SD101 - Page 53

Promi SD™ User Manual ver 1.7
www.initium.co.kr
53
20)
AT+BTLPM,n<cr>
<cr><lf>OK<cr><lf>
Enable or disable the low power
mode of dongle.
n = 1 or 0
21)
AT&V<cr>
<cr><lf>S0: m0;S1:
m1; … Sn:
mn<cr><lf>
<cr><lf>OK<cr><lf>
View all the values of internal S-
registers
22)
AT+BTSD?<cr>
<cr><lf>bdaddr of
secured device
1<cr><lf>
<cr><lf>bdaddr of
secured device
1<cr><lf>
<cr><lf>OK<cr><lf>
Query the bd-addresses of secured
devices
23)
AT+BTCSD<cr>
<cr><lf>OK<cr><lf>
Clear the list of secured devices
24)
AT+BTFP,n<cr>
<cr><lf>OK<cr><lf>
Force paring when connecting as
master
25)
AT+UARTCONFIG,baudrate,parity,st
opbit,handshaking<cr>
<cr><lf>OK<cr><lf>
Sets the configuration of UART
interface. Possible values are;
baudrate
=1200,4800,9600,19200,38400,5760
0 or 115200.
parity = N(o parity), E(ven parity) or
O(dd parity).
stop = 1 or 2.
Handshaking = 1 or 0
(If ‘1’, hardware handshaking will be
used. If ‘0’, handshaking function of
Promi SD will be turned off)
26)
AT+SETESC,nn<cr>
<cr><lf>OK<cr><lf>
Sets the escape sequence character.
‘nn’ should be ASCII code (Decimal),
and printable character. Default
escape charater is ‘+++’
27)
AT+PINQ?<cr>
<cr><lf>OK<cr><lf>
For Periodic Inquiry. Promi SD will try
to inquire nearby Bluetooth devices
periodically and deliver the inquired