7
3. Screwed the balance weight on the tone arm through the center, please refer to below instruction.
If the sound is distortion, please turning the balance weight clockwise or counterclockwise.
4. Put the rubber mat on the turntable.
5. Release TONE ARM REST by gently pushing hold-down clip to the right. This will unlock tone arm
from its arm rest. Re-lock the hold-down clip when moving the unit to another location.
How to Replace the Turntable Stylus (Needle)
Removing old stylus
1. Set a screwdriver at the tip of the stylus and push
down in the direction “A”.
2. Remove the stylus by pulling it forward and down.
Installing a new stylus
1. Hold the tip of the stylus and insert the other edge
by pressing in the direction “B”.
2. Push up in the direction “C” until it locks at the tip.
To Next Page
Loading...
