Inovance MD200 - Page 4

Safety Information and Precautions
- 3 -
■
Approvals
The following table lists the certications and standards that the product may comply with. For details about the acquired certications,
see the certication marks on the product nameplate.
Certication Directives Standard
CE
EMC directive 2014/30/EU EN 61800-3
LVD directive 2014/35/EU EN 61800-5-1
RoHS directive 2011/65/EU EN 50581
TUV - EN 61800-5-1
•
The above EMC directive is complied with only when the EMC electric installation requirements are strictly
observed.
•
Machines and devices used in combination with this drive must also be CE certied and marked. The integrator
who integrates the drive with the CE mark into other devices has the responsibility of ensuring compliance with CE
standards and verifying that conditions meet European standards.
•
The installer of the drive is responsible for complying with all relevant regulations for wiring, circuit fuse protection,
earthing, accident prevention and electromagnetic (EMC regulations). In particular fault discrimination for
preventing fire risk and solid earthing practices must be adhered to for electrical safety (also for good EMC
practice).
•
For more information on certication, consult our distributor or sales representative.
Appllicant Suzhou Inovance Technology Co., Ltd.
AC Drive
Model MD200 series
Made In China
Manufacturer
Suzhou Inovance Technology Co.,Ltd.
Ａ급기기（업무용 방송통신기자재）
이 기기는 업무용(Ａ급) 전자파적합기기로서 판매자
또는 사용자는 이 점을 주의하시기 바라며,가정외의
지역에서 사용하는 것을 목적으로 합니다.
■
Adjusting Servo Drive Parameters
The Servo Drive when it leaves the factory with default settings should enable the user toget started quickly to check on the basic
mechanical running conditions. At a later time,ne tuning to optimize the operation/performance can be undertaken.
Such parameter tuning should be done by qualied personnel who have prior trainingon Servo Drives. Some parameter settings can
have adverse reactions if manipulatedincorrectly and care should be taken especially during the commissioning startup stages to prevent
personnel from engaging the machine.
This manual provides a complete list of the parameters with functional description and care should always be taken whenever
parameters are adjusted during a live runningstartup. Inovance Technology and Authorized Distributors can provide product trainingand if
in doubt seek advice.
■
Motor Thermal Protection
Motor thermal protection is not assessed by UL.
Note