Inovance MD280NT37P - Page 134

Parameter Description MD280/MD280N User Manual
- 134 -
Where,
SB1: Running enable button and stop button
SB2: Running button
K: The switch for direction selection.
Terminal UP/DOWN
velocity
Factory
default
value
1.00Hz/s
F2-07
Setup range 0.01Hz/s to 100.00Hz/s
It is used to set the change rate when the setup frequency is adjusted with
terminals UP/DOWN.
AI1 minimum input
Factory
default value
0.02V
F2-08
Setup value 0.00V to F2-10  
Corresponding setup
of AI1 minimum input
Factory
default value
0.0%
F2-09
Setup value -100.0% to100.0%
AI1 maximum input
Factory
default value
10.00V
F2-10
Setup value F2-08 to 10.00V
Corresponding setup of
AI1 maximum input
Factory
default
value
0
0 F2-12
F2-11
Setup value
1 Set by AI2
Corresponding setup
of AI1 maximum
input
Factory
default value
100.0%
F2-12
Setup value -100.0% to 100.0%
AI1 input filtering
time
Factory
default value
0.10s
F2-13
Setup value 0.00s to 10.00s
The parameters above mentioned define the relationship between analog
input voltage and the analog input setup value. When analog input voltage
exceeds the set maximum input or minimum input limit, the voltage beyond
the limit will be calculated by maximum input or minimum input as shown in
Fig. 6-9.
AI input filtering time: AI1 input signal will be filtered.The longer the filtering
efesotomasyon.com