Inovance MD330H - Page 232

MD380 User Manual Desc
ription of Function Codes
- 231 -
Function Code Parameter Name Setting Range Default
A2-48
Digital setting of
torque upper limit in
speed control mode
0.0%–200.0%
150.0%
A2-51
Excitation adjustment
proportional gain
0–20000
2000
A2-52
Excitation adjustment
integral gain
0–20000
1300
A2-53
Torque adjustment
proportional gain
0–20000
2000
A2-54
Torque adjustment
integral gain
0–20000
1300
A2-55
Speed loop integral
property
Unit's digit: Integral separated
0: Disabled
1: Enabled
0
A2-56
Field weakening mode
of synchronous motor
0: No eld weakening
1: Direct calculation
2: Adjustment
0
A2-57
Field weakening
degree of
synchronous motor
50%–500%
100%
A2-58
Maximum eld
weakening current
1%–300%
50%
A2-59
Field weakening
automatic adjustment
gain
10%–500%
100%
A2-60
Field weakening
integral multiple
2–10
2
A2-61 Motor 2 control mode
0: Sensorless ux vector control (SFVC )
1: Closed-loop vector control (CLVC)
2: Voltage/Frequency (V/F) control
0
A2-62
Motor 2 acceleration/
deceleration time
0: Same as motor 1
1: Acceleration/Deceleration time 1
2: Acceleration/Deceleration time 2
3: Acceleration/Deceleration time 3
4: Acceleration/Deceleration time 4
0
A2-63 Motor 2 torque boost
0.0%: Automatic torque boost
0.1%–30.0%
Model
dependent
A2-65
Motor 2 oscillation
suppression gain
0–100
Model
dependent