Inovance MD380 Series

Description of Function Codes
MD380 User Manual
- 174 -
*URXS)2XWSXW7HUPLQDOV
7KH0'SURYLGHVDQDQDORJRXWSXW$2WHUPLQDODGLJLWDORXWSXW'2WHUPLQDODUHOD\
terminal and a FM terminal (used for high-speed pulse output or open-collector switch signal
output) as standard. If these output terminals cannot satisfy requirements, use an optional
,2H[WHQVLRQFDUGWKDWSURYLGHVDQ$2WHUPLQDO$2DUHOD\WHUPLQDOUHOD\DQGD'2
WHUPLQDO'2
Function Code Parameter Name Setting Range Default
F5-00 FM terminal output mode
0: Pulse output (FMP)
1: Switch output (FMR)
0
The FM terminal is programmable multiplexing terminal. It can be used for high-speed pulse
output (FMP), with maximum frequency of 50 kHz. Refer to F5-06 for relevant functions of
FMP. It can also be used as open collector switch signal output (FMR).
Function Code Parameter Name Default
F5-01 FMR function selection 0
F5-02 Relay (T/A-T/B-T/C) function selection 2
F5-03 Extension card relay (P/A-P/B-P/C) function selection 0
F5-04 '2IXQFWLRQVHOHFWLRQ 1
F5-05 ([WHQVLRQFDUG'2IXQFWLRQVHOHFWLRQ 4
7KHVH¿YHSDUDPHWHUVDUHXVHGWRVHOHFWWKHIXQFWLRQVRIWKH¿YHGLJLWDORXWSXWWHUPLQDOV
T/A-T/B-T/C and P/A-P/B-P/C are respectively the relays on the control board and the
extension card.
The functions of the output terminals are described in the following table.
Table 6-5 Functions of output terminals
Value Function Description
0 No output The terminal has no function.
1 AC drive running
:KHQWKH$&GULYHLVUXQQLQJDQGKDVRXWSXWIUHTXHQF\
FDQEH]HURWKHWHUPLQDOEHFRPHV21
2 Fault output
:KHQWKH$&GULYHVWRSVGXHWRDIDXOWWKHWHUPLQDO
EHFRPHV21
3
Frequency-level
detection FDT1 output
Refer to the descriptions of F8-19 and F8-20.
4 Frequency reached Refer to the descriptions of F8-21.
5
Zero-speed running
(no output at stop)
If the AC drive runs with the output frequency of 0, the
WHUPLQDOEHFRPHV21,IWKH$&GULYHLVLQWKHVWRSVWDWH
WKHWHUPLQDOEHFRPHV2))
6
Motor overload
pending
The AC drive judges whether the motor load exceeds
the overload pending threshold before performing the
protection action. If the pending threshold is exceeded, the
WHUPLQDOEHFRPHV21)RUPRWRURYHUORDGSDUDPHWHUVVHH
the descriptions of F9-00 to F9-02.
efesotomasyon.com