Inovance MD380 Series

MD380 User Manual Desc
ription of Function Codes
- 175 -
Value Function Description
7
AC drive overload
pending
7KHWHUPLQDOEHFRPHV21VEHIRUHWKH$&GULYHRYHUORDG
protection action is performed.
8
Set count value
reached
7KHWHUPLQDOEHFRPHV21ZKHQWKHFRXQWYDOXHUHDFKHV
the value set in FB-08.
9
Designated count
value reached
7KHWHUPLQDOEHFRPHV21ZKHQWKHFRXQWYDOXHUHDFKHV
the value set in FB-09.
10 Length reached
7KHWHUPLQDOEHFRPHV21ZKHQWKHGHWHFWHGDFWXDOOHQJWK
exceeds the value set in FB-05.
11 PLC cycle completed
:KHQVLPSOH3/&FRPSOHWHVRQHF\FOHWKHWHUPLQDO
outputs a pulse signal with width of 250 ms.
12
Accumulative running
time reached
If the accumulative running time of the AC drive exceeds
WKHWLPHVHWLQ)WKHWHUPLQDOEHFRPHV21
13 Frequency limited
If the set frequency exceeds the frequency upper limit or
lower limit and the output frequency of the AC drive reaches
WKHXSSHUOLPLWRUORZHUOLPLWWKHWHUPLQDOEHFRPHV21
14 Torque limited
In speed control mode, if the output torque reaches the
torque limit, the AC drive enters the stall protection state
DQGPHDQZKLOHWKHWHUPLQDOEHFRPHV21
15 5HDG\IRU581
If the AC drive main circuit and control circuit become
stable, and the AC drive detects no fault and is ready for
581WKHWHUPLQDOEHFRPHV21
16 AI1 larger than AI2
:KHQWKHLQSXWRI$,LVODUJHUWKDQWKHLQSXWRI$,WKH
WHUPLQDOEHFRPHV21
17
Frequency upper limit
reached
If the running frequency reaches the upper limit, the
WHUPLQDOEHFRPHV21
18
Frequency lower limit
reached (no output at
stop)
If the running frequency reaches the lower limit, the terminal
EHFRPHV21,QWKHVWRSVWDWHWKHWHUPLQDOEHFRPHV2))
19
8QGHUYROWDJHVWDWH
output
If the AC drive is in undervoltage state, the terminal
EHFRPHV21
20
Communication
setting
Refer to the communication protocol.
21 Reserved Reserved.
22 Reserved Reserved.
23
Zero-speed running 2
(having output at stop)
If the output frequency of the AC drive is 0, the terminal
EHFRPHV21,QWKHVWDWHRIVWRSWKHVLJQDOLVVWLOO21
24
Accumulative power-
on time reached
If the AC drive accumulative power-on time (F7-13)
H[FHHGVWKHYDOXHVHWLQ)WKHWHUPLQDOEHFRPHV21
25
Frequency level
detection FDT2 output
Refer to the descriptions of F8-28 and F8-29.
26 Frequency 1 reached Refer to the descriptions of F8-30 and F8-31.
27 Frequency 2 reached Refer to the descriptions of F8-32 and F8-33.
28 Current 1 reached Refer to the descriptions of F8-38 and F8-39.
29 Current 2 reached Refer to the descriptions of F8-40 and F8-41.
efesotomasyon.com