Inovance MD380 Series

Description of Function Codes
MD380 User Manual
- 204 -
Function Code Parameter Name Description
F9-37 Frequency upon 1st fault
Same as F9-17–F9-24.
F9-38 Current upon 1st fault
F9-39 Bus voltage upon 1st fault
F9-40
Input terminal state upon
1st fault
F9-41
2XWSXWWHUPLQDOVWDWH
upon 1st fault
F9-42
AC drive state upon 1st
fault
F9-43
Power-on time upon 1st
fault
F9-44
Running time upon 1st
fault
Function Code Parameter Name Setting Range Default
F9-47
Fault protection
action selection 1
8QLWVGLJLW0RWRURYHUORDG(UU
00000
0: Coast to stop
1: Stop according to the stop mode
2: Continue to run
Ten's digit (Power input phase loss, Err12)
Same as unit's digit
Hundred's digit (Power output phase loss, Err13)
Same as unit's digit
Thousand's digit (External equipment fault, Err15)
Same as unit's digit
Ten thousand's digit (Communication fault, Err16)
Same as unit's digit
F9-48
Fault protection
action selection 2
8QLWVGLJLW(QFRGHUIDXOW(UU
00000
0: Coast to stop
1: Switch over to V/F control, stop according to the
stop mode
2: Switch over to V/F control, continue to run
7HQVGLJLW((3520UHDGZULWHIDXOW(UU
0: Coast to stop
1: Stop according to the stop mode
Hundred's digit: reserved
Thousand's digit (Motor overheat, Err25)
Same as unit's digit in F9-47
Ten thousand's digit (Accumulative running time
reached)
Same as unit's digit in F9-47
efesotomasyon.com