To Next PageTo Next Page
Need help?Do you have a question about the Inovance MD500T90G-INT and is the answer not in the manual?
General| Model | MD500T90G-INT |
|---|---|
| Category | Controller |
| Power | 90 kW |
| Output Current | 180 A |
| Control Mode | V/F Control, Vector Control |
| Cooling Method | Forced Air Cooling |
| Humidity | 5% to 95% (non-condensing) |
| Enclosure Rating | IP20 |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheat, Short Circuit |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C to 60°C |
| Altitude | Up to 1000 m |
| Voltage | 380-480 VAC |
| Input Voltage | 380-480 VAC |
| Communication Interface | RS485 |
Emphasizes extreme care when working with AC drives due to high voltages.
Outlines responsibilities for safe installation, commissioning, and maintenance of the AC drive.
Specifies requirements for working temperature, cooling, mounting location, and vibration.
Provides guidelines for mounting orientation and necessary clearances for installation.
Explains methods for backplate and through-hole mounting the AC drive.
Shows a general wiring diagram of the AC drive system with peripheral devices.
Details the terminal arrangements and functions for the main circuit connections.
Explains the terminal arrangements and functions for control circuit wiring.
Explains how to enable, set, and remove password protection for programming the AC drive.
Provides a step-by-step flowchart for initial AC drive setup and parameter configuration.
Details the process of setting motor parameters from the nameplate for accurate auto-tuning.
Guides through performing motor auto-tuning for optimal performance.
Explains the process of motor auto-tuning for obtaining optimal motor parameters.
Lists various protection functions available for the AC drive and motor.
Provides crucial safety warnings before performing troubleshooting procedures.
Offers solutions for common problems encountered during trial runs, like oscillation or poor response.
Provides a table linking operating panel display codes to fault names, causes, and possible solutions.
Lists common symptoms and their potential causes and solutions for troubleshooting.
