Inovance MD880-01S-0751-4 - Page 46

2 Mechanical Installation
- 45 -
■
Removing and re󶍾tting of the cover of structures T2 to T9
Removal
Remove the two 󶍾xing screws on the
cover using a screwdriver. Hold the
cover while screwing out the screws to
prevent it from falling.
Hold the cover with both hands, push it up, and
then pull it out downwards to remove the cover.
Re󶍾tting
Hold the cover with both hands, align
the cover and cabinet, and then push
it in slantways from the bottom.
Tighten the two 󶍾xing screws.
Figure 2-24 Removing and re󶍾tting of the cover of structures T2 to T9
■
Removing and re󶍾tting of the covers of structures T10 to T12
1) Removing the covers of structures T10 to T12
2) Remove the four screws on the lower cover using a screwdriver. Then, hold the
lower cover with both hands and pull it out.
3) Remove the six screws on the upper cover. Then, hold the cover with both hands
and lift it in the arrow direction shown below to remove the upper cover.