Inovance MD880-01S-0751-4 - Electrical Installation

2 Mechanical Installation
- 46 -
 
Figure 2-25 Removing the covers of structures T10 to T12
4) Re󶍾tting the covers of structures T10 to T12
Re󶍾t the covers in a reverse procedure to removal.
5) Hold the upper cover with both hands and align the top of the upper cover with the
󶍾xing hooks at the top of the cabinet, as shown in the following 󶍾gure. Align the
six screw holes on the upper cover to the 󶍾xing holes on the cover of the cabinet.
Then, secure the six screws.
6) Hold the lower cover with both hands and align the four screw holes on the lower
cover to the 󶍾xing holes on the base of the cabinet. Then, secure the four screws.
 
Figure 2-26 Re󶍾tting the covers of structures T10 to T12