Inovance MDKE9 Series User Manual

4 Function and Application
- 25 -
4
Inverter
03 Device Control
04 Authority
05 System Set
Back Select18:00:02
Loc
Stop
• 06 System Control
Inverter
• 01 Parameter Copy
02 Update SOP
Back Select18:00:02
Loc
Stop
Inverter
• 01 Read Parameter
02 Write Parameter
Back Select
18:00:02
Loc
Stop
1） Read parameter
This operation shall read all parameters of the system.
Set the user-dened part of the le name before performing reading parameters. The user-dened part
consists of 5 digits. use and to select the digit, and / to change the value (range: 0-9
and A-Z) of the digit. The format of the le name is as follows: Device name-5-digit user-dened part-time.
ipv
For example: Inverter--00002-0302134905.ipv, Where inverter is the device name, 00002 is the user-
dened part, 02 March, 13: 49: 05.
Press to read and copy the parameters after the le name is set. "Handle succeed" will display on
the interface after reading and copying parameter is nished. Specic reason will be displayed if reading
and copying parameter failed.
Figure 4-11 Read parameter
Inverter
01 Read Parameter
Back Select18:00:02
Loc
Stop
18:00:02
58%
Reading Parameter…
00 : 00
0 : 无功能
0 : 无功能
Parameter Copy
Succeed
18:00:02
44%
Reading Parameter…
00：02
Back OK18:00:
02
Loc
Input File Name
0 0 0 0 2
Back OK
• 02 Write Parameter
2） Write parameters
Different from reading parameters, there are two kinds of parameter write mode: "all copy mode" and
"non-motor parameter copy mode". All copy mode copies all the parameters except the communication
parameters. The non-motor parameter copy mode is tailored for parameters of certain parameter range.
Please check the user manual of the device.
The procedures of write parameters is as follows:

Inovance MDKE9 Series Specifications

General

Brand	Inovance
Model	MDKE9 Series
Category	Control Panel
Language	English