Inovance MDKE9 Series - Device Burning and Software Updates

4 Function and Application
- 26 -
4
①
Press to select the target device;
②
Enter "write parameter" menu, then press to select the already read parameter le;
③
In the copy mode interface, select the parameter copy mode you need;
④
Wait until the parameter download completes.
Figure 4-12 Example of write parameters
Inverter
01 Read Parameter
• 02 Write Parameter
Back Select18:00:02
Loc
Stop
18:00:02
30%
Select File
Back Select18:00:02
18:00:02
58%
Writing Parameter… …
00 : 00
0 : 无功能
0 : 无功能
Parameter Handle Succeed
Back OK
• Inverter-00002-0302134905.
ipv
Inverter-00000-0226143108.ipv
Inverter-00001-0226143649.ipv
Writing Parameter…
00 : 03
Note
All parameter les that are copied, saved and read are stored in SD card, ensure that the SD
card is properly installed before using the parameter copy function.
Example: Copy all the parameters in 2# device to 3# device.
①
Enter “key login” menu, enter the password to log into the system;
②
Press to select the 2# device;
③
Read the parameters in 2# device, and name it as “00002”;
④
Press , select 3# deivce;
⑤
Write the “00002” parameter to 3# device via “all copy mode”.
4.7.2 Device Burning
You may update the program directly through the panel. Burn steps are as follows:
①
Copy the burning le to the SD card under SYS/PROGRAM directory;
● Take USB connection mode as example, the display after the completion of the wiring are as
follows:
Figure 4-13 USB Connection
Select USB Connect Mode
USB mode
• USB disk
Back Select
0 : 无功能
0 : 无功能
USB disk