8 Inspection and Maintenance
-
290
-
Safety Information
To Prevent Electric Shock
◆
Never perform wiring at power-on.
◆
capacitors can discharge safely. Wait at least the required interval before power-on again.
◆
Never modify wiring, disconnect the cable, remove the optional board or replace the
cooling fan while the controller is running.
◆
Make sure to connect the grounding terminal of the motor to ground. Otherwise, you will
◆
personnel.
◆
Installation, wiring, commissioning, repairing, checking and component replacement can
only be performed by personnel familiar with installation, commissioning or maintenance
Warning
To Prevent Fire
◆
NEVER run the controller with the protective cover removed.
◆
The drawings in the manual are sometimes shown without covers or protective guards.
operations in accordance with the instructions.
◆
cable connection from overheating after becoming loose.
◆
Never misconnect the main circuit. This is to ensure that the input voltage is within the
◆
incombustible surfaces such as a metal wall.
Caution
◆
◆
Never install or remove the motor while the controller is running. Failure to comply may
result in electric shock and damage to the controller.
◆
Use shielded cables for control circuit wiring.
◆
Meanwhile, connect the shield to ground reliably at one end to prevent controller
malfunction.
◆
Never modify the controller circuit. Failure to comply will damage the controller.
◆
Make sure to connect the controller output terminals to the motor terminals correctly.
Considering the characteristics of the synchronous motor, you can perform parameter
setting.
◆
Never operate the controller that has been damaged. This is to prevent further damage to
external equipment.
To Next Page
Loading...
Need help?
General
