Inovance SV660F Series - List of Warning Codes; Resettable Warning List

List of Warning Codes
‑87‑
5 List of Warning Codes
Table 5–1 Resettable warning list
Fault code Fault subcode Name Fault level Resettable
E108
E108.0
Storage parameter write error
NO.3 Yes
E108.1
Storage parameter read error
NO.3 Yes
E108.2
Invalid check on data written in
EEPROM
NO.3 Yes
E108.3 Invalid check on data read in EEPROM NO.3 Yes
E110 E110.0
Frequency‑division pulse output
setting error
NO.3 Yes
E121 E121.0
Duplicate S‑ON command
NO.3 Yes
E122 E122.0
Multi‑turn absolute encoder setting
error
NO.3 Yes
E510 E510.0
Frequency division pulse output
overspeed
NO.3 Yes
E550 E550.2
External switchover wait warning
NO.3 Yes
E600 E600.0
Inertia auto‑tuning failure
NO.3 Yes
E601
E601.0
Homing warning
NO.3 Yes
E601.1
Homing switch error
NO.3 Yes
E601.2
Homing mode setting error
NO.3 Yes
E730 E730.0
Encoder battery warning
NO.3 Yes
E900 E900.0
DI emergency braking
NO.3 Yes
E902
E902.0
DI setting invalid
NO.3 Yes
E902.1
DO setting invalid
NO.3 Yes
E902.2
Torque reach setting invalid
NO.3 Yes
E908
E908.0 Model identification check code error NO.3 Yes
E908.1
Inverter model setting mismatch
NO.3 Yes
E920 E920.0
Braking resistor overload
NO.3 Yes
E922 E922.0
Resistance of the external
regenerative resistor too small
NO.3 Yes
E924 E924.0
Regenerative transistor over‑
temperature
NO.3 Yes
E941 E941.0
Modified parameters activated at next
power‑on
NO.3 Yes
E942 E942.0
Parameter storage too frequent
NO.3 Yes
E950 E950.0
Positive limit switch warning
NO.3 Yes
E952 E952.0
Negative limit switch warning
NO.3 Yes
E958 E958.0
Reverse position reference overtravel
in process segment position mode
NO.3 Yes
E980 E980.0
Encoder algorithm error
NO.3 Yes
EA41 EA41.0
Torque fluctuation compensation
failure
NO.3 Yes