RECEIVER CONTROLS & OPERATIONS
STEREO
Tuner stereo signal detected.
TUNED
Tuner station detected.
SLEEP
Unit in Sleep mode
Tuner frequency unit
MEMORY
SLEEP
TUNEDSTEREO
L
R
DISPLAY MESSAGES
The following is an example of all the display messages you may encounter while using your receiver. Specific messages re referen-
ced within the section(s) they apply.
TUNING THE RECEIVER
1.Push the FM/AM button on the front panel (or the AM/FM
button on the remote) to activate the tuner.
2.When using the remote you must press the AM/FM button
on the remote again to select the FM or AM band.
Press the SCAN + button on your remote button to move up
the AM or FM band. Press the SCAN - arrow button on your
remote to move down the AM or FM band. You may press and
hold SCAN + or SCAN- buttons 3 seconds to
find next station.
automatically
Use the AUTO feature to automatically search for stations of
sufficient strength.
Press and hold AUTO button for 3 seconds on the remote.
Radio frequencies will be browsed and radio station stored
automatically. When all available radio stations are stored or if
all 32 memory locations are full, the auto preset will stop.
1.If there is interference, modify the location of the antenna until the
optimal sound is heard. TV and other electronic devices could be the
cause of interferences so try to position the antenna away of them.
2.Weak signal can affect the "auto Search function".Adjust the antenna
for better reception for more efficient search.
SELECT THE AM/FM BAND
8
KHz
MH
z
MH
KHz
z
NOTES:
MANUAL TUNING
AUTO TUNING
Weak signal can affect the "Automatic Preset Storing Function" efficie-
ncy. Adjust the antenna for the best reception for more efficient search.
NOTE:
To Next Page
Loading...
