STEREO RECEIVER AMPLIFIER IS-HC040918
INSTALLING BATTERIES IN THE
REMOTE CONTROL
Since the remote controller will be used for many of this
unit control operations, you should begin by installing the
supplied batteries.
1.Turn the remote controller over and slide the battery
compartment cover in the direction of the arrow.
2. Insert the batteries(AAA,R03,UM-4 TYPE) according to
the polarity markings on the inside of the battery compa-
rtment.
3.Close the battery compartment cover.
NOTES ABOUT THE REMOTE CONTROL
Batteries Replacement
If you find that the remote controller must be used close to the
main unit, the batteries are weak. Replace both batteries with
new ones.
REMOTE CONTROL OPERATION RANGE
Within approximately
6m(19.7feet)
30
30
1.The area between the remote controller and the main unit must be
clear of large obstacles.
2.Do not expose the remote control sensor to strong lighting, in
particular an inverter type fluorescent lamp. Otherwise, the remote
controller may not work properly. If necessary, position the main unit
away from direct lighting.
ABOUT REMOTE CONTROL
3
Danger of explosion if battery is incorrectly
replaced.
CAUTION
VCR
AUX
CD
DVD
1 2
3 4
5
6
7 8
A
B
C
D
MEMORY
SCAN
AUTO
IS-HC040918
POWER
TUNER
MUTE
BALANCE
VOL
AM/FM
TREBLE
BASS
SLEEP
1.Use AAA,R03,UM-4 batteries.
2.Be sure the polarities are correct.(See the illustration inside the bat-
tery compartment.)
3.Remove the batteries if the remote controller is not used for an exte-
nded period of time. If batteries leak, dispose of them immediately.
4.Avoid touching the leaked material and contact with clothing, etc.
Clean the battery compartment thoroughly before installing new batt-
eries.
NOTES:NOTES:
FIRST THINGS FIRST
To Next Page
Loading...
Need help?
General
