49
NS-28D220NA16 28" 720p 60Hz, LED TV
www.insigniaproducts.com
Playing TV audio only
You can turn off the picture on your TV and listen to
the program audio only.
1 Press MENU.
2 Press
or to highlight CHANNELS, then press
or ENTER.
3 Press
or to highlight Audio Only, then press
ENTER or
.
4 Press
or to select On.
5 Press MENU, ENTER, or
to return to the previous
menu, or press EXIT to close the menu.
Changing channel settings
This section covers:
• Automatically scanning for channels
•Hiding channels
• Setting up a favorite channel list
•Viewing a favorite channel
• Adding or changing a channel label
• Checking the digital signal strength
Automatically scanning for channels
When you scan for channels, your TV searches for
channels with signals and stores the channel
information in the channel list. When you press CH
or CH , your TV goes to the next or previous
channel in the channel list.
If the TV signal source changes, for example you
change from an outdoor antenna to cable TV (no
box), you need to scan for channels.
1 Press MENU.
2 Press
or to highlight CHANNELS, then press
or ENTER.
3 Press
or to highlight Auto Channel Search,
then press ENTER or .
4 Press
or to highlight Cable/Satellite Box,
Cable from the wall, or Antenna, then press
ENTER.
Notes
• The picture turns off in about five
seconds.
• Audio Only works only when the
input source is TV, and your TV is
receiving a broadcast signal.
• To exit audio only mode, press any
button. When you exit audio only
mode, the Audio Only option is
automatically reset to Off.
NS-28D220NA16_14-1311_MAN_V1_ENG.book Page 49 Friday, April 24, 2015 9:15 AM
To Next Page
Loading...
