59
32" 720p 60Hz LED TV
www.insigniaproducts.com
Remote control
General
Good sound,
but poor
color.
• Adjust the contrast, color, and
brightness settings. See Adjusting
the TV picture on page 38.
Audio noise.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device at a time to
determine which device is causing
interference. After you have
determined which device is causing
interference, move it further from
the TV to eliminate the interference.
No output
from one of
the speakers.
• Adjust the audio balance. See
Adjusting sound settings on
page 40.
• Test the TV’s speakers. See Testing
the TV speakers on page 56. If one
or both of the speakers fails, try one
of the following solutions:
• Make sure that the audio cables
are connected correctly and
securely to your TV.
• Make sure that the audio cables
are connected to the AUDIO OUT
jacks on the connected device.
• Try a different set of audio cables.
• Make sure that the sound on the
connected device is not muted.
• Try connecting the device to a
different TV. If you do not hear
sound, the problem is with the
device.
After images
appear.
• Do not display a still image, such as
a logo, game, or computer image,
for an extended period of time. This
can cause a permanent after-image
to be burned into the screen. This
type of damage is not covered by
your warranty.
Problem Solution
Problem Solution
Remote
control does
not work.
• Make sure that the power cord is
plugged into a working outlet.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly at
the remote control sensor on your
TV. For the location of the remote
control sensor, see Aiming the
remote control on page 27.
• The supplied batteries are wrapped
tightly in clear plastic. Make sure
that you have removed this plastic
from the batteries.
• Make sure that the batteries are
installed correctly. See Installing
remote control batteries on
page 27.
• Replace dead batteries with new
batteries. See Installing remote
control batteries on page 27.
Trouble
programming
your existing
universal
remote
control.
• See instructions in Programming
universal remote controls on
page 28.
• Codes are subject to change. For
up-to-date codes, go to
www.insigniaproducts.com/remotecodes
• Replace dead batteries with new
batteries.
• Refer to the User Guide that
accompanied your universal remote
control and contact the
manufacturer if problems persist.
Problem Solution
No power.
• Make sure that the power cord is
plugged into a working outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord back in
and turn on your TV.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device, at a time,
then turning on your TV to
determine which device is causing
interference. After you have
determined which device is causing
interference, move it further from
the TV to eliminate the interference.
To Next Page
Loading...
