7
165-Can Beverage Cooler
www.insigniaproducts.com
Control and display panel
Setting up your beverage cooler
Before using your cooler
• Remove the exterior and interior packaging.
• Let the cooler stand upright for approximately half an hour before connecting
it to power. This reduces the possibility of a malfunction in the cooling system
from improper handling during transportation.
• Clean the interior surface with a damp, warm cloth.
Finding a suitable location
• This cooler is designed to be built into your cabinets. Place it on a floor,
countertop, or cabinet that is strong enough to support the cooler when it is
fully loaded.
BUTTON FUNCTION
Hold for five seconds to set your cooler to “Standby” mode (the cooler
stops cooling and light turns off).
Press to set whether the interior light stays on or off while the door is
closed.
Press to increase the temperature by one degree.
Press to decrease the temperature by one degree.
Press to change the display between Fahrenheit and Celcius.
Notes:
• Touch the control panel lightly when pressing the keys.
• To avoid scratching the control panel, do not touch it with sharp objects.
Change temperature unit (°F/°C)Lower temperature
Light
Display Raise Temperature
Standby
To Next Page
Loading...
