7
Dual-Zone Wine and Beverage Center
www.insigniaproducts.com
Control and display panels (both)
Setting up your wine cooler
Before using your cooler
• Remove the exterior and interior packing.
• Let the cooler stand upright for approximately four hours before
connecting it to power. This reduces the possibility of a malfunction in
the cooling system from improper handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Finding a suitable location
• This cooler is designed to be built-in or free standing.
• Place your cooler on a floor, countertop, or cabinet that is strong
enough to support the cooler when it is fully loaded.
• Locate the cooler away from direct sunlight and sources of heat (stove,
heater, radiator, and so on). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
BUTTON FUNCTION
Press to turn the power on or off.
Press to turn the interior light on or off.
Press to raise the temperature in the selected zone.
Press to lower the temperature in the selected zone.
Press both buttons simultaneously to change the display from F° to C° or back
again.
Notes
• Touch the control panel lightly when pressing the keys.
• To avoid scratching the control panel, do not touch it with
sharp objects.
Up and down buttons
Light button DisplayPower button
NS-BC2ZSS8_17-0590_MAN_V1_ENG.fm Page 7 Friday, July 28, 2017 8:34 AM
To Next Page
Loading...
Need help?
General
