12
NS-OTR16SS8Q
www.insigniaproducts.com
5 Tape the template in place so that it is centered on the vertical line and the top edge is aligned with the
horizontal line.
6 Mark points A and B on the wall with a pencil.
7 If the stud is on the center line, mark point C on the wall with a pencil.
OR
If the stud is not on the center line, mark two holes on either side of point C that align with the studs.
8 Drill holes through the template at points you marked. If the hole lines up with a stud, drill a 3/16” hole.
Otherwise, drill a 5/8" hole for the toggle bolts.
Notes
At least three holes must be used for mounting.
You’ll need:
Vertical line in the center
Top of the template aligned
with the horizontal line
Note: Depending on your stud locations, your installation may look
different. You should mount to at least one stud.
Rear wall template
Pencil
Duct tape
Electric drill with 3/16” and 5/8” bits
Level
Ruler or tape measure
NS-OTR16SS8Q_17-0283_IST-MAN_V1.fm Page 12 Friday, July 7, 2017 4:20 PM
To Next Page
Loading...
