Insignia NS-OTR16SS8Q - Step 4: Option B

To Next Page

To Previous Page

NS-OTR16SS8Q

www.insigniaproducts.com

Step 4: Option B - Cutting a vent opening

1 Use a saber or keyhole saw to cut out the shaded area K through the rear wall.

2 Remove the rear wall template.

Note

If a wall stud is within 6 in. (15.2 cm) of the vertical center line, you cannot use this

installation option.

You’ll need:

Saw

(saber, hole, or keyhole)

NS-OTR16SS8Q_17-0283_IST-MAN_V1.fm Page 22 Friday, July 7, 2017 4:20 PM

Insignia NS-OTR16SS8Q - Step 4: Option B - Cutting a Vent Opening