33
1.6 Cu. Ft. Over-the-Range Microwave
www.insigniaproducts.com
5 Insert wood screw(s) through the mounting plate and into the hole(s) drilled in the stud(s), then tighten both the
wood screw(s) and toggle bolt(s) with a Phillips screwdriver to mount the plate. Make sure that the plate is
centered before tightening fully.
Caution
Be careful to avoid pinching your fingers between the back of the mounting plate
and the wall.
You’ll need:
Mounting plate
Wall
Toggle wing
Toggle bolt
Wood screws
Mounting plate (Qty. 1)
(ships attached to microwave)
Phillips screwdrivers
Toggle bolts
NS-OTR16SS8Q_17-0283_IST-MAN_V1.fm Page 33 Friday, July 7, 2017 4:20 PM
To Next Page
Loading...
