www.insigniaproducts.com
15
28" Square Fire Table - Black
STEP 4: Attaching the table to the base assembly
You need:
1 Place the table (C) face down on a pad or piece of cardboard (to prevent damage), then turn the base assembly over
onto the table so that the holes in the base assembly align with the holes in the table.
2 Secure the base assembly to the table (C) with four M6 x 12 mm bolts (AA), then tighten with the Phillips screwdriver
(FF).
AA M6 × 12 mm bolt (4)
C table
FF Phillips screwdriver
Bottom of your fire table
To Next Page
Loading...