www.insigniaproducts.com
34
Reverse osmosis system
If your cold water supply is connected to a reverse osmosis system:
• The water pressure to the reverse osmosis system needs to be between 30 and 125 psi (207 and 862 kPa).
• The water pressure at the inlet valve on your refrigerator needs to be between 30 psi to 125 psi (207 kPa to 862 kPa).
If the water pressure to the reverse osmosis system is less than 40 psi and 60 psi (276 kPa and 414 kPa):
• Check the sediment filter on the system, then replace the filter if necessary.
• Allow the storage tank on the system to refill after heavy usage.
• If the water pressure is still too low, your refrigerator's water filter may be further reducing the water pressure. Remove
the water filter.
Maintaining the ice bucket
• To clean the ice bucket, wash with a mild detergent, rinse well, and dry it thoroughly. Do not use harsh or abrasive
cleaners or solvents.
• If ice cubes in the ice bucket spill out over the drawer, clear the ice cubes that spilled out of the drawer.
• If there is a power failure, ice cubes may melt, and then freeze together when the power comes back on, causing the
dispenser to stop working. To prevent this problem, after a power failure, pull out the ice bucket and residual ice or
water.
• If you're not getting ice:
• If you recent emptied the ice bucket, wait until your ice maker produces additional ice.
• If there is no ice produced after 6 hours, contact customer service because there may be an issue with the ice maker.
• If there is ice in the bucket but it won't come out, contact customer service because there may be an issue with the
motor.
Replacing the LED light
Storing your refrigerator
1 Unplug your refrigerator from the power outlet.
2 Remove all food.
3 Clean your refrigerator.
4 Take off the doors, and leave the shelves in place so that children cannot easily climb inside.
Moving your refrigerator
1 Unplug your refrigerator from the power outlet.
2 Remove all food, then clean and dry your refrigerator thoroughly.
3 Securely tape down all loose items inside your refrigerator.
4 Tape the door shut, then tape the power cord to the back of your refrigerator.
5 Make sure that your refrigerator does not tilt more than 45° from the upright position during transportation.
CAUTION:
• Do not put food in the ice bucket. If you store food in the ice bucket, the food can strike the ice maker when you open or close the
door, causing damage to the ice maker.
• To avoid cold air leaking out from cabinet, keep the water dispenser parts installed even if the water dispenser was out of use.
CAUTION: The LED light must be replaced by a qualified service technician.
WARNING: If a door accidentally closes while a child is inside your refrigerator, the child may suffocate.
CAUTION: Your refrigerator is heavy. When moving your refrigerator for cleaning or service, be sure to cover the floor with cardboard
or hardboard to avoid floor damage. Always pull your refrigerator straight out when moving it. Do not wiggle or “walk” your
refrigerator when trying to move it, as floor damage could occur.
Note: If your refrigerator has been placed in a horizontal or tilted position for any period of time wait four hours before plugging it in
to allow the oil to settle into the compressor.
To Next Page
Loading...
Need help?
General
