Inspire Ignite Wireless - Combi Boiler With Existing Room Thermostat

The majority of combi boilers can be wired using the 4 wire installation method. If
your boiler manual suggests a 3 wire install, then refer to Fig 7 , remembering to
remove the link wire in the boiler (if required) and add a link wire between
terminals 4 & 5 on the Receiver.
After the wiring has been completed, replace the front cover and secure using the
two screws - DO NOT OVERTIGHTEN . Restore power to the circuit.
COMBI BOILER WITH EXISTING ROOM THERMOSTAT
Wired Thermostat
Remove the existing Thermostat wiring from the boiler, then follow the steps on
page 7 for "Combi Boiler without Room Thermostat or Timer" .
Wireless Thermostat with built in receiver
Wireless Thermostats with a receiver built into the front panel of the boiler, (e.g.
Drayton LP10RF) this MUST be removed from the boiler. Then follow the steps on
page 7 for "Combi Boiler without Room Thermostat or Timer" .
Wireless Thermostat with external receiver
Make a careful note of the locations of the existing wiring at the receiver, then
remove the old receiver.
Install the Ignite Receiver as described in Installation - Wall Mount on page 11.
Install the previously identified wires into the appropriate terminals on the Ignite
Receiver. If 4 wires are present, see Fig 6 . If only 3 wires, then see Fig 7 ,
remembering to add the link wire between terminals 4 & 5.
After the wiring has been completed, replace the front cover and secure using the
two screws - DO NOT OVERTIGHTEN . Restore power to the circuit.
8
Fig 7