BASIC FUNCTIONS (HOT WATER)
Off
Your hot water will be switched off.
Auto
Your Thermostat will follow its Hot Water Schedule.
The default is: (This can be adjusted via your online account)
On between 06:00 and 08.30
On between 12:00 and 13:00
On between 18:00 and 20:00
Man
Your hot water will be switched on and will keep your hot water cylinder at the
temperature set by your cylinder thermostat.
Boost
This is used if you would like to switch your hot water on for a set period of time.
The default is 1 hour. When pressed, ‘BOOST HW’ will flash to indicate that boost is
currently active.
Your hot water will switch on for the programmed length of time. After this time
has expired, the hot water function will return to the previous function.
Adjusting the Mode
Pressing the 'HW MODE' key will cycle through the above modes.
Program Advance
This is used if you would like to ‘jump’ to the next scheduled hot water setting.
Press the ‘ADV HW’ key to ‘jump’ to the next setting in your schedule. It will only
have an effect if the hot water function is in auto mode. Pressing the ‘ADV HW’ key
a 2nd time will cancel the program advance and the unit will revert back to the
current profile setting.
SETTING THE CLOCK
If you have an Internet connection, this will be done automatically. If you are
outside of the United Kingdom. you can specify your time zone on the ‘Setup’
page within your online account. To set the clock manually, press, and hold the
‘BOOST CH’ and ‘BOOST HW’ keys. Use the ‘/\’ and ‘\/’ keys to set the hours, then
press ‘ADV CH’ this will take you to the minutes and then the days (1 = Sunday, 7 =
Saturday) which are set in a similar way. To exit, press the ‘BOOST CH’ and ‘BOOST
HW’ keys simultaneously.
15
To Next Page
Loading...
