Inspired Flight IF1200A - Disassemble and Store the Aircraft

IF1200A Pilot Operating Handbook 16. Arm and Disarm
16. Arm and Disarm
● Arm means to start the propellers spinning.
● Disarm means to stop the propellers from spinning.
Step
Action
Arming
1
Verify each item on the Preflight Checklist (see the end of this User Manual).
2
Arm the aircraft by bringing the left joystick stick down and towards the right (see
below). The motors start spinning in an idle state.
3
Continue to hold the stick in the low throttle position and verify that all motors
and propellers are spinning correctly.
Note: a Jeti DS-12 is shown below. These instructions also apply to the HereLink
hand controllers.
Disarming
1
Position Mode: Once the aircraft has landed, hold the throttle down and to the left to
stop the propellers.
Autonomous Mode: The aircraft automatically disarms upon landing.
End of Procedure
IFT Doc Num 102094, Rev 1.02 Page 38