Inspired Flight IF1200A - Page 90

IF1200A Pilot Operating Handbook Appendix
Connect HereLink and QGroundControl Through a WiFi Network
This section describes how to wirelessly connect a HereLink to QGroundControl through a local
WiFi network.
Note 1: The HereLink uses an Android operating system. The instructions below reflect
this.
Note 2: Before performing the following procedure, connect the device on which QGC is
installed (tablet or laptop), to the WiFi network that the HereLink will be connected to.
Note 3: In order to confirm the wireless connection between the HereLink and GCS,
power on the aircraft before performing the following procedure.
Connect HereLink and QGroundControl through a WiFi Network
Step
Action
1
On the Herelink, go to the Settings -> About phone -> Status information -> IP
address. Write down the IP address of the HereLink.
2
On the Herelink, go to Settings -> Connections -> WiFi, and connect the HereLink
to a local WiFi network.
3
On the GCS, open QGroundControl (QGC).
4
locate the QGroundControl icon in the upper-left corner of the screen (see below).
Select (click) this icon to open the Select Tool window (see next page).
Continued next page.
IFT Doc Num 102094, Rev 1.02 Page 87