EasyManuals Logo

Inspur NF5486M5 Installation Guide

Inspur NF5486M5
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
The rack, chassis or guide rails may cause scratches, please be careful.
机柜或者服务器机箱、导轨可能造成划伤
When installing new servers into the rack in use, please be aware of electric shock.
在正在使用的机柜中安装新服务器时,请谨防触电
V1.0
请注意!
Warnings!
When installing 2U or bigger servers, at least 2 people are needed.
安装2U或更大的机型时,至少需要2个人
During the installation process, please don’t block the vents on the server, especially the vents
on the front and rear of the server.
安装时请注意不要阻塞服务器上的通孔,尤其是服务器前、后部的通风孔
Please remove the protective film on the server surface before using.
请在使用之前将服务器壳上的保护膜撕去
Please leave 15cm minimum of clearance on the front and rear sides of the server for proper
ventilation.
服务器的前、后部需至留出15厘米空间,以便于系统散热
Please install air baffles for the position without device installed, to make sure that the server
can get enough air flow, and to avoid air turbulence in the server room.
没有安装设备的机柜位,请始终安装挡风盲板,以确保服务器获足够的气,并避免机房气
紊乱
Servers are high-power electrical appliances, and they should be installed into the dedicated
cabinets with vents or professional water-cooled cabinets, to prevent system failures caused
by overheating.
服务器是高功耗电器,能安装在带有通风孔的专用机柜,或者专水冷机柜,以免过热造成
统失效
If it needs to install more than one device,
please load from the bottom up, and load the
heaviest items first.
如果要安装多台设备,先从机柜靠下的空位开始,并将较重的设安装在机下部
Please note the cabinets bearing capacity, power supply capacity and heat dissipation
capacity, be sure not to install devices beyond the cabinet’s bearing capacity.
请注意机柜的承重、供及散热能力,切勿安装超出机柜承载能力设备
For the convenience of using the front and rear ports of the server and cabling, leave 70mm
minimum of clearance between the front end of the server and the inner side of the cabinets
front door, and leave 150mm minimum of clearance between the rear end of the server and
the inner side of the cabinets rear door.
为了便于使用服务器前后部的接口,并便于布线,服务器前部与柜前门内之间至少留出70
毫米、后部与机柜后门内侧之间至少出150米距离
If the device is more than 15kg, 2 people are needed at least.
安装超过15千克的设备,至少需2个人
If the device is more than 30kg, 3 people are needed at least.
安装超过30千克的设备,至少需3个人
If the device is more than 50kg, 4 people are needed at least.
安装超过50千克的设备,至少需4个人
.
.
Please keep this document for checking in the future.
请保留本文档,以便于日后查阅
15kg
30kg
50kg
PN
Inspur Rack-Mounted Server
Installation Guide
浪潮机架式服务器
上架安装指南

Other manuals for Inspur NF5486M5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Inspur NF5486M5 and is the answer not in the manual?

Inspur NF5486M5 Specifications

General IconGeneral
BrandInspur
ModelNF5486M5
CategoryServer
LanguageEnglish

Related product manuals