Instant Ace Plus User Manual

18
Clean Program
Pulse Cleaning
Use Clean program to remove superficial food debris and residue from pitcher.
Follow steps 2-8 in “Getting Started” section of this manual.
For stubborn food residue, refer to “Deep Cleaning” section below.
Deep Cleaning
Minerals in water may deposit at bottom of pitcher. Periodic deep cleaning will ensure the
blender’s longevity.
1. Add 1 cup (8 oz / 250 mL) white vinegar or citric acid, and 1 cup (8 oz / 250 mL) of warm
water to pitcher.
2. Allow solution to sit for at least one hour.
3. Connect power cord to a 120V power source.
4. Place lid on pitcher and turn lid clockwise until it clicks into place. Lid braces must fit
over glass lid brace catches, located on pitcher.
5. Place pitcher on blender base.
6. If the food residue is especially stubborn, select Soup.
7. Touch Start to heat water to boiling. Once water is hot, touch Cancel.
8. Touch Clean.
9. Touch Start to begin pulse motion cleaning.
INSTANT TIP: Stubborn Stains
Follow steps 1 -3 above. Then, with blender unplugged, scrub with the cleaning brush or
a sponge, and rinse. Repeat as necessary.
WARNING
Blades are sharp. To avoid the risk of severe injury, unplug blender before inserting cleaning brush into pitcher.

Instant Ace Plus Specifications

General

Heating element	Yes
Voltage	120 V
Frequency	60 Hz
Capacity	56 oz
Material	Stainless steel
Speed settings	3
Power	1300 watts