Instant Ace Plus - Select Program

7
Getting Started
6
Add Dish Soap
Turn lid cap counter-clockwise to remove lid cap from lid.
Add a few drops of dish soap to pitcher.
Fit lid cap into lid and turn clockwise until it clicks into place.
7
Select Program
Touch Clean.
Touch Start.
Blender will run high speed cycles, pausing between pulses.
When Program has completed, display will indicate “End”.
8
Empty Pitcher
Lift the pitcher up and off the blender base.
When pitcher is removed from blender base, display will
go blank.
Turn the lid counter-clockwise and lift up and off the pitcher.
Discard soapy water and rinse pitcher, lid, and lid cap with
warm, clear water.
CAUTION
Add a minimal amount of dish soap to the pitcher. Too
much dish soap results in excess foam, which may
cause the pitcher to overow.
WARNING
Do not reach into pitcher while blender is in use. Rotating blades can cause damage and serious injury. Do not put hands,
spatulas, or any other utensil into pitcher while blender is running.
40
48
56
OZ
32
24
40
48
32
24
COLD
HOT
MAX