Cooking with the Omni Toaster Oven
Initial Test Run
Follow these steps to ensure your oven is operating properly.
1. Open the oven door.
Place the cooking pan on the bottom of the cooking chamber.
Close door.
2. Plug the power cord into a 120V power source.
Display indicates OFF signifying that the oven is in Standby mode.
3. Touch the Air Fry Smart Program key on the display.
Note: The default Air Fry Smart Program cooking temperature is 400ºF.
4. Turn the Time dial [-] or [+] to adjust the cooking time to 20 minutes.
5. Touch the green Start
The display indicates On when the oven is in Preheat mode.
Note: The Temp and Time are preset by the Air Fry Smart Program, however,
you can turn the Temp [-] or [+] and Time [-] or [+] dials to adjust the cooking
temperature or time.
6. When the oven reaches the Smart Program cooking temperature,
Note: For the test run, do not add food to the cooking chamber.
7. Partway through the Air Fry Smart Program cooking time, the oven will beep
and indicate turn Food
Note: The turn Food reminder only appears when using Air Fry, Bake and
Roast Smart Programs and only if Rotate is not turned on.
Note: Cooking will recommence after 10 seconds whether food has been
turned or not.
8. The display will count down the last minute of cooking time in seconds.
When the Smart Program is complete, the display indicates End and the fan
turns on automatically to cool the oven.
Note: The Omni Toaster Oven emits a Smart Reminder sound that the food is
ready at 5, 20, and 60 minutes after the Smart Program ends.
CAUTION
The oven will be hot during and after cooking. Do not touch hot surfaces. Always use
oven mitts to remove cooking trays. Allow the oven to cool to room temperature, then
clean the accessories and cooking chamber. Refer to Care & Cleaning in this manual.
16
To Next Page
Loading...
Need help?
General
