Integra DRX-4.2 User Manual

135
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Loudness Plus On When this is set to "On", you can enjoy even subtle
nuances of audio expression at low volume. This
is only available when the THX listening mode is
selected.
THX Loudness Plus
THX Loudness Plus is a new volume control
technology mounted on THX Ultra and THX Select-
certied receivers.
With THX Loudness Plus, home theater audience
can experience the rich details of surround sound
at any volume level.
If the volume is turned down below the reference
level, elements of sound in a certain range are lost
or the sound is perceived di󰀨erently by the listener.
THX Loudness Plus compensates for the tonal and
spatial shifts that occur when the volume level is
reduced, by intelligently adjusting the levels of the
surround channels and their frequency response in
the environment.
This enables users to experience the true impact
of soundtracks regardless of the volume setting.
THX Loudness Plus is automatically applied when
listening in any THX listening mode. In the newly
developed THX Cinema, THX Music and THX
Games modes, the optimum THX Loudness Plus
setting is applied according to the type of content.
3. Audio Adjust
 1. Multiplex/Mono
Change the settings of multiplex audio playback.
Setting Item Default Value Setting Details
Multiplex Input
Channel
Main Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit’s display.
Mono Input
Channel
Left + Right Set the input channel to play 2-ch digital sources
such as Dolby Digital, or 2-ch analog/PCM sources
in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
Mono Output
Speaker
Center Set the speaker to output monaural audio in the
Mono listening mode.
"Center": Audio is output from the center speaker.
"Left/Right": Audio is output from the front L/R
speakers.
• If the item cannot be selected even though
connection is correct, check if the setting in "2.
Speaker" - "Conguration" - "Speaker Channels"
matches the number of connected channels.

Integra DRX-4.2 Specifications

General

Brand	Integra
Model	DRX-4.2
Category	Stereo Receiver
Language	English