Integra DRX-4.2 - Page 136

136
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
 2. Dolby
Change the setting of when Dolby signals are input.
Setting Item Default Value Setting Details
Loudness
Management
On When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is O󰀨, the Late Night function that allows you to
enjoy surround at low volumes is xed to o󰀨 when
playing Dolby Digital Plus/Dolby TrueHD.
"On": When this function is used
"O󰀨": When this function is not used
 3. DTS
Change the setting of when DTS signals are input.
Setting Item Default Value Setting Details
DTS Auto
Surround
On When inputting DTS signals that include extended
channel information, the optimum listening mode is
automatically selected according to the extended
information contained in the input signal and the
speaker conguration of this unit when playing in
the straight decoding listening mode.
"On": When this function is used
"O󰀨": Audio is played using the same number
of channels in the input signal according to the
speaker conguration of this unit.
• If this function is set to "O󰀨", the ES Matrix and
ES Discrete listening modes cannot be selected.
 4. LFE Level
Set the low-frequency e󰀨ect (LFE) level for Dolby Digital series, DTS series,
Multichannel PCM, and DSD signals.
Setting Item Default Value Setting Details
LFE Level 0 dB Select the low-frequency e󰀨ect (LFE) level of each
signal from "0dB" to "-∞dB". If the low-frequency
e󰀨ect sound is too strong, select "-20dB" or "-∞dB".
 5. Volume
Change the Volume settings.
Setting Item Default Value Setting Details
Volume Display Absolute Switch the volume display between the absolute
value and relative value. The absolute value 82.0 is
equivalent to the relative value 0.0dB.
"Absolute": Absolute value such as "0.5" and "99.5"
"Relative": Relative value such as "-81.5dB" and
"+18.0dB"
• If the absolute value is set to 82.0, "82.0Ref"
appears on the display.
Mute Level -∞dB Set the volume lowered from the listening volume
when muting is on. Select a value from "-∞dB",
"-40dB" and "-20dB".
Maximum Volume O󰀨 Set the maximum value to prevent the volume
from becoming too loud. Select a value from "O󰀨",
and "50" to "99". (When "Volume Display" is set to
"Absolute")
Power On Volume Last Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "Min", "0.5" to "99.5"
and "Max". (When "Volume Display" is set to
"Absolute")
• You cannot set a higher value than that of
"Maximum Volume".
Headphone Level 0.0 dB Adjust the output level of headphones. Select a
value between "-12.0 dB" and "+12.0 dB".